Communication Connectors And Terminals; Pu Connector - Mitsubishi Electric FR-A800 Series Instruction Manual

2.7

Communication connectors and terminals

2.7.1

PU connector

 Mounting the operation panel or the parameter unit on the enclosure
surface
• Having an operation panel or a parameter unit on the enclosure surface is convenient. With a connection cable, the
operation panel or the parameter unit can be mounted to the enclosure surface and connected to the inverter.
Use the cable option FR-CB2[ ] or the following connector and cable available on the market. (To install the operation
panel, the optional connector (FR-ADP) is also required.)
Securely insert one end of the cable into the PU connector and the other end into the connection connector on the
parameter unit or the FR-ADP attached on the operation panel until the stoppers are fixed.
Parameter unit (FR-PU07)
(option)
NOTE
• Refer to the following table when fabricating the cable on the user side. Keep the total cable length within 20 m.
 Communication operation
• Using the PU connector as a computer network port enables communication operation from a personal computer, etc.
When the PU connector is connected with a personal, FA or other computer by a communication cable, a user program
can run to monitor the inverter or read and write parameters.
Communication can be performed with the Mitsubishi inverter protocol (computer link operation).
For the details, refer to
84
2. INSTALLATION AND WIRING
2.7 Communication connectors and terminals
Downloaded from ManualsNet.com
Operation panel (FR-DU08)
Operation panel (FR-LU08)
(option)
Name
Communication
Cable compliant with EIA-568 (such as 10BASE-T cable)
cable
page 659.
search engine
Parameter unit connection cable
(FR-CB2[ ]) (option)
Operation panel connection
connector (FR-ADP)
(option)
Remarks