Copying And Verifying Parameters On The Operation Panel; Parameter Copy - Mitsubishi Electric FR-A800 Series Instruction Manual

5.18
Copying and verifying parameters on the operation
panel
Pr.CPY setting value
0.---
1.RD
2.WR
3.VFY
NOTE
• When the copy destination is other than the FR-A800 series or when parameter copy is attempted after the parameter copy
reading was stopped, the product series error "
• Refer to the parameter list on
• When the power is turned OFF or an operation panel is disconnected, etc. during parameter copy writing, write again or check
the setting values by parameter verification.
• When parameters are copied from a different-capacity inverter, there are parameters with different initial values depending on
the inverter capacity, so the setting values of some parameters will be automatically changed. After performing a parameter
copy from a different-capacity inverter, check all the parameter settings. (Refer to the parameter list
parameters with different initial values depending on individual inverter capacity.)
• While password protection is enabled, parameter copy and parameter verification cannot be performed. (Refer to
• If parameters are copied from an older inverter to a newer inverter that has additional parameters, out-of-range setting values
may be written in some parameters. In that case, those parameters operate as if they were set to initial values.

5.18.1 Parameter copy

• Inverter parameter settings can be copied to another inverter.
 Reading the parameter settings in the inverter and storing them in the
operation panel
Operating procedure
1.
Connect the operation panel to the source inverter.
2.
Selecting the parameter setting mode
Press
3.
Selecting the parameter
Turn
"
4.
Reading to and storing in the operation panel
Turn
operation panel. (It takes about 30 seconds to read and store all the settings. During reading, "
5.
End of reading and storing
"
NOTE
• "
744
5. PARAMETERS

5.18 Copying and verifying parameters on the operation panel

Downloaded from ManualsNet.com
Initial display
Copy the parameters from the source inverter to the operation panel.
Write the parameters stored in the operation panel to the target inverter.
Verify parameters in the inverter and operation panel. (Refer to
page 864
to choose the parameter setting mode. (The parameter number read previously appears.)
to " " (Parameter copy) and press
" appears.
to change the set value to "
" and " " are displayed alternately after the reading and storing are completed.
" appears when a parameter read error occurred. Perform the operation from step 3 again.
search engine
Description
" appears.
for the availability of parameter copy.
.
". Press to start reading the parameter settings by the
page 746.)
(page 166) for details on
page 348.)
" blinks.)