Mitsubishi Electric FR-A800 Series Instruction Manual page 758

Device No.
RY23
RY24
RY25
RY3A
*1 Torque control cannot be performed with a PM motor.
Downloaded from ManualsNet.com
Signal
Torque command / torque limit (RAM)
Torque command / torque limit (RAM,
EEPROM)
Instruction code execution request
Error reset request flag
search engine
When "1" is set in the torque command / torque limit (RY23), the set torque
command / torque limit (RWw2) is written to RAM of the inverter.
After the writing completes, "1" is set in the torque command / torque limit setting
completion (RX23).
The following value is written to RAM.
*1
• During torque control : Torque command value
• During speed control / position control: Torque limit value
When "1" is set in the torque command / torque limit (RY24), the set torque
command / torque limit (RWw2) is written to RAM and EEPROM of the inverter.
After the writing completes, "1" is set in the torque command / torque limit setting
completion (RX24).
The following value is written to RAM and EEPROM.
*1
• During torque control : Torque command value
• During speed control / position control: Torque limit value
To change the torque command or the torque limit consecutively, be sure to write
data to the inverter RAM.
When "1" is set in the instruction code execution request (RY25), processes
corresponding to the instruction codes set to RWw10, 12, 14, 16, 18 and 1A are
executed. "1" is set in the instruction code execution completed (RX25) after
completion of instruction codes. When an instruction code execution error occurs,
a value other than "0" is set in the reply code (RWr10, 12, 14, 16, 18, and 1A).
When "1" is set in the error reset request flag (RY3A) at an inverter fault, the
inverter is reset, then "0" is set in the error status flag (RX3A). Refer to
669 for operation conditions of inverter reset.
Description
5. PARAMETERS
5.21 CC-Link IE Field Network (FR-A800-GF)
1
2
3
4
5
6
page
7
8
9
10
757