Mitsubishi Electric FR-A800 Series Instruction Manual page 353

Pressing the [FUNC] key on the direct setting screen displays the function menu.
Direct setting
Direct setting 1
Direct setting 2
 Dedicated parameter list function
Pressing the [PrSET] key of the FR-PU07-01 displays the dedicated parameter list. Parameters that need to be set first for the
PID extended display setting are listed.
Dedicated parameter list
No.1
No.2
No.3
NOTE
• The display of parameters other than the above may be changed due to changes in C42 or C44. Set the PID monitor indicator
before changing the settings of other parameters.
• To use the direct setting on the LCD operation panel, set Pr.1000 Direct setting selection. (Refer to
 GOT initial setting (PU connector) (Pr.999 = "10, 12")
Pr.
79 Operation mode selection
118 PU communication speed
119 PU communication stop bit length / data length 1
120 PU communication parity check
121 PU communication retry count
122 PU communication check time interval
123 PU communication waiting time setting
124 PU communication CR/LF selection
340 Communication startup mode selection
414 PLC function operation selection
*1 The setting is changed when Pr.414 = "0" (initial setting).
 Initial setting with the GOT2000 series
• When "FREQROL 500/700/800, SENSORLESS SERVO" is selected for "Controller Type" in the GOT setting, set Pr.999
= "10" to configure the GOT initial setting.
• When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT setting, the GOT automatic
connection can be used. When "FREQROL 800 (Automatic Negotiation)" is selected for "Controller Type" in the GOT
setting and the GOT automatic connection is not used, set Pr.999 = "12" to configure the GOT initial setting. (Refer to
701.)
 Initial setting with the GOT1000 series
• Set Pr.999 = "10" to configure the GOT initial setting.
NOTE
• Always perform an inverter reset after the initial setting.
• For details on connection with GOT, refer to the Instruction Manual of GOT.
352
5. PARAMETERS
5.7 (E) Environment setting parameters
Downloaded from ManualsNet.com
Parameter to be set
Pr.133 PID action set point
Pr.755 Second PID action set point
Parameter to be set
Pr.999 Automatic parameter setting
Pr.934 PID display bias coefficient
Pr.935 PID display bias analog value
Name
search engine
Initial value Pr.999 = "10"
0 1
192 192
10
2 1
1 9999
9999 9999
9999 0 ms
1 1
0 0
0 —
page 340.)
Pr.999 = "12" Refer to page
1 389
1152
0
1
9999 670
9999
0 ms
1
0 398
*1
646
2
page