Mitsubishi Electric FR-A800 Series Instruction Manual page 657

 Digital source (monitor item) selection
• Select the digital sources (input/output signals) to be set to Pr.1038 to Pr.1045 from the following table. When a value
other than the ones in the following table is set, "0" (OFF) is applied for indication.
Setting
Signal name
value
0 —
1 STF
2 STR
3 AU
4 RT
5 RL
6 RM
7 RH
8 JOG
9 MRS
10 STP (STOP)
11 RES
12 CS
21 X0
22 X1
23 X2
24 X3
25 X4
26 X5
27 X6
28 X7
29 X8
30 X9
31 X10
32 X11
33 X12
34 X13
35 X14
36 X15
37 DY
 Trigger setting (Pr.1025, Pr.1035 to Pr.1037, Pr.1046, Pr.1047)
• Set the trigger generating conditions and the trigger target channels.
Pr.1025
setting
0 Tracing starts when inverter enters an fault status (protective function activated)
1 Tracing starts when analog monitor satisfies trigger conditions
2 Tracing starts when digital monitor satisfies trigger conditions
3 Tracing starts when either of analog or digital monitor satisfies trigger conditions (OR)
4 Tracing starts when both of analog or digital monitor satisfies trigger conditions (AND)
• Set the trigger generation conditions for the analog monitor.
Pr.1036
setting
Sampling starts when the analog data targeted for the trigger exceeds the value specified
0
at the trigger level
Sampling starts when the analog data targeted for the trigger falls below the value specified
1
at the trigger level
*1 In Pr.1037, set the number obtained by adding 1,000 to the trigger level.
656
5. PARAMETERS
5.14 (A) Application parameters
Downloaded from ManualsNet.com
Remarks
For details on the signals, refer to
page 521.
For details on the signals, refer to
the Instruction Manual of the FR-
A8AX (option).
Trigger generating conditions
Trigger generation conditions
search engine
Setting
Signal name
value
101 RUN
102 SU
103 IPF
For details on the signals, refer to
104 OL
page
105 FU
106 ABC1
107 ABC2
121 DO0
122 DO1
123 DO2
For details on the signals, refer to
124 DO3 the Instruction Manual of the FR-
A8AY (option).
125 DO4
126 DO5
127 DO6
128 RA1
For details on the signals, refer to
129 RA2 the Instruction Manual of the FR-
A8AR (option).
130 RA3
Remarks
473.
Selection of trigger
target channel
—
Pr.1035
Pr.1046
Pr.1035, Pr.1046
Pr.1035, Pr.1046
Trigger level setting
Set the trigger level from 600 to
*1
1400 (-400 to 400% ) in
Pr.1037.