Ic Data Array; Figure 4.8 Memory-Mapped Ic Address Array - Hitachi SH7751 Hardware Manual

Superh risc engine
Table of Contents

Advertisement

MMU is enabled at this time, comparison is performed after the virtual address specified by
data field bits [31:10] has been translated to a physical address using the ITLB. If the addresses
match and the V bit is 1, the V bit specified in the data field is written into the IC entry. In
other cases, no operation is performed. This operation is used to invalidate a specific IC entry.
If an ITLB miss occurs during address translation, or the comparison shows a mismatch, an
interrupt is not generated, no operation is performed, and the write is not executed. If an
instruction TLB multiple hit exception occurs during address translation, processing switches
to the instruction TLB multiple hit exception handling routine.
31
Address field
1 1 1 1 0 0 0 0
31
Data field
V
: Validity bit
A
: Association bit
: Reserved bits (0 write value, undefined read value)
4.5.2

IC Data Array

The IC data array is allocated to addresses H'F100 0000 to H'F1FF FFFF in the P4 area. A data
array access requires a 32-bit address field specification (when reading or writing) and a 32-bit
data field specification. The entry to be accessed is specified in the address field, and the longword
data to be written is specified in the data field.
In the address field, bits [31:24] have the value H'F1 indicating the IC data array, and the entry is
specified by bits [12:5]. CCR.IIX has no effect on this entry specification. Address field bits [4:2]
are used for the longword data specification in the entry. As only longword access is used, 0
should be specified for address field bits [1:0].
The data field is used for the longword data specification.
The following two kinds of operation can be used on the IC data array:
1. IC data array read
Longword data is read into the data field from the data specified by the longword specification
bits in the address field in the IC entry corresponding to the entry set in the address field.
Rev. 3.0, 04/02, page 104 of 1064
24
23
Tag

Figure 4.8 Memory-Mapped IC Address Array

13
12
Entry
10 9
5 4 3 2 1 0
A
1 0
V

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sh7751r

Table of Contents