Pin Configuration; Register Configuration; Table 17.1 Smart Card Interface Pins; Table 17.2 Smart Card Interface Registers - Hitachi SH7751 Hardware Manual

17.1.3

Pin Configuration

Table 17.1 shows the smart card interface pin configuration.

Table 17.1 Smart Card Interface Pins

Pin Name
Serial clock pin
Receive data pin
Transmit data pin
17.1.4

Register Configuration

The smart card interface has the internal registers shown in table 17.2. Details of the SCBRR1,
SCTDR1, SCRDR1, and SCSPTR1 registers are the same as for the normal SCI function: see the
register descriptions in section 15, Serial Communication Interface (SCI).
With the exception of the serial port register, the smart card interface registers are initialized in
standby mode and in the module standby state as well as by a power-on reset or manual reset.
When recovering from standby mode or the module standby state, the registers must be set again.

Table 17.2 Smart Card Interface Registers

Name
Serial mode register
Bit rate register
Serial control register
Transmit data register
Serial status register
Receive data register
Smart card mode
register
Serial port register
Notes: *1 Only 0 can be written, to clear flags.
*2 The value of bits 2 and 0 is undefined.
Abbreviation I/O
SCK I/O
RxD Input
TxD Output
Abbreviation R/W
SCSMR1 R/W
SCBRR1 R/W
SCSCR1 R/W
SCTDR1 R/W
SCSSR1 R/(W)*
SCRDR1 R
SCSCMR1 R/W
SCSPTR1 R/W
Function
Clock input/output
Receive data input
Transmit data output
Initial
Value P4 Address
H'00 H'FFE00000
H'FF H'FFE00004
H'00 H'FFE00008
H'FF H'FFE0000C
1
H'84 H'FFE00010
H'00 H'FFE00014
H'00 H'FFE00018
2
H'00* H'FFE0001C
Rev. 3.0, 04/02, page 681 of 1064
Area 7 Access
Address Size
H'1FE00000 8
H'1FE00004 8
H'1FE00008 8
H'1FE0000C 8
H'1FE00010 8
H'1FE00014 8
H'1FE00018 8
H'1FE0001C 8