HP Designjet 3D Service Manual page 119

Starting Up Failed Minor Errors (15.XX)
Code Description
15,01 Startup state activation
failed
15,02 Timeout period expired
while starting up
Controller Load Failed Minor Errors (17.XX)
Code Description
17,01 LG_COMMAND Failed on Controller
17,02 LG_COMMAND Timeout
Temperature Failed to Regulate Minor Errors (18.XX)
Corrective Actions
Software use only
1. See CFG file for additional error details.
2. Replacement controller board or hard drive
is gendered incorrectly.
3. If printer is in Dynamic Mode:
a. Issue may be a network timeout due to
improper DHCP settings on the
network. Verify by looking at CFG, if
code reads:
- MASTER logger: Punching nameserver
xxx.xxx.xxx.xxx through the firewall.
b. If using printer firmware version 2230
try workaround. Contact CS for
workaround instructions.
c. Upgrade printer firmware to a version
newer than 2230.
4. Material Bay Connection timeout. Refer to
error code 14,139.
Corrective Actions
Software use only.
Software use only.
-103