Line Filter; Removing The Line Filter - HP Designjet 3D Service Manual

Line Filter

Required Tools
Hardware

Removing the line filter

1. Open the electronics bay. See
2. Touch the metal plate of the electronics bay cover to discharge any static
3. Remove L1- 1 and N1- 1 spade connectors from the right side of the board
4. Remove L2- 1 and N2- 1 Spade connectors from the left side of the board
-194
5
• ⁄ " nut driver or standard screwdriver.
16
• Phillips screwdriver
1
• 6-32 x ⁄ " Phillips pan head screws (x3)
4
page 171
electricity.
by pulling back on the connector. See
Figure 108: L1-1 and N1-1 spade connector locations
by pulling up on the connector. See
"Opening the electronics bay" on
Figure 108.
Disconnect the N1- 1
spade connector
Disconnect the L1- 1
spade connector
Figure 109.