HP Designjet 3D Service Manual page 374

26. Measure and record the diameter of circle D along the center line
27. Add the lengths derived from steps 24 and 25 (A-D and D-G) and then
28. Open HP Designjet 3D Diagnostic Software and select the Current Mod-
29. Open the Open Gantry Calibration Dialog box in HP Designjet 3D
30. In the Part Calibration section, there are six boxes: LEFT, RIGHT, FRONT,
31. Once the values have been entered, click on the green check mark.
32. Toggle the system power switch to accept the new values.
33. Run a test part to verify system is operating correctly.
-358
Figure 351: Measuring distances from outside edges of D and G
between A and G. See Figure 352
Figure 352: Measuring diameter of circle D
subtract the width of circle D derived from step 26. Record this total as
"Left Front"
eler from the pull down menu.
Diagnostic Software.
REAR, LEFT FRONT and LEFT REAR. Enter the measurements in the
appropriate box.