Circuit Breaker; Removing The Circuit Breaker - HP Designjet 3D Service Manual

Circuit Breaker

Required Tools

Removing the circuit breaker

1. Open the electronics bay. See
2. Touch the metal plate of the electronics bay cover to discharge any static
3. Remove the Load and CB1 spade connectors from the circuit breaker by
4. Remove the CB1 Line and CB2 spade connectors from the circuit
-196
5
• ⁄ " nut driver or standard screwdriver.
16
• Phillips screwdriver
page 171
electricity.
pulling up on the connectors. See
Figure 1 1 1: Load and CB1 spade connector locations
CB1
breaker by pulling up on the connectors. See
Figure 1 12: CB1 Line and CB2 spade connector locations
CB1 Line
"Opening the electronics bay" on
Figure 1 1 1.
Figure 1 12.
Load
CB2