HP Designjet 3D Service Manual page 338

Figure 302: Removing the Z stage panel
6. Remove the 4 Z motor energy chain mounting screws with a
wrench. See Figure 303.
7. Cut the tie wraps holding from around Z stage energy chain. See
303.
Figure 303: Remove the Z motor energy chain
Remove the 2
mounting screws
Remove the 2
mounting screws
8. Loosen but do not remove the Z stage leadscrew mounting bracket set
9
screws using a ⁄ " allen wrench. See
64
3
⁄
32
Cut the
wire tie
Figure 304.
" allen
Figure
Cut the
wire tie
-322