HP Designjet 3D Service Manual page 270
Hide thumbs
Also See for Designjet 3D:
- User manual (30 pages) ,
- Assembly instructions manual (12 pages) ,
- Assembly instructions (5 pages)
Table of Contents
Advertisement
7. Using a cutters, remove the X motor cable connector wire tie. See
Cut and remove
wire tie
8. Disconnect the X motor cable by pressing in on the tab and pulling out-
-254
Figure 202: X belt tension adjustment bolt location
Loosen X belt
adjustment bolt
203.
Figure 203: X motor wire tie locations
ward. See
Figure 204.
Figure
Advertisement
Table of Contents
Troubleshooting
