Xy Table Components; Y Home Sensor; Removing The Y Home Sensor - HP Designjet 3D Service Manual

XY Table Components

Y Home Sensor

Required Tools
1
• ⁄ " nut driver or standard screwdriver.
4
Hardware
3
• 6-32 x ⁄ " slotted screw (x1)
8

Removing the Y home sensor

1. Remove the top panel. See
2. Disconnect the Y home cable by pressing in on the tab and pulling out-
ward. See Figure 196.
Figure 196: Y Home sensor cable location
1
3. Using a ⁄ " nut driver or standard screwdriver, remove the mounting
4
screw. See Figure 197.
"Removing the top panel" on page 161
Disconnect the Y
Home cable
-249