Material; Door; Setting The Serial Number; Materials - HP Designjet 3D Service Manual

Material

Model Latched
Model in Head
Support Latched
Support in Head

Door

Door Latched The state of the door latch solenoid
Door Open The state of the door switch

Setting the Serial Number

To set the printer serial number enter the serial number in the "Product Serial
Number" field and click on the green check mark. The serial number
displayed in this field is the current serial number of the product.

Materials

Every spool has a SmartSpool EEPROM attached that tracks information
about the material remaining on the spool. The following information is
provided for each spool:
Serial Number
Material Type
Manufacturing Lot
Manufacturing Date
Use Date
Initial Quantity
Current Quantity

Adjusting XY Tip Offset

See "Offset Calibrations" on page 338.
The model material cartridge latch state
The state of the modeling material in the printer.
True = material moved out of cartridge
False = material not moved out of cartridge.
The support material cartridge latch state.
The state of the support material in the printer.
True = material moved out of the cartridge.
False = material not moved out of the cartridge
This is a unique number assigned to each spool.
This is the type of material on the spool.
For example:
P430 - is a standard modeling material
SR30 - is a standard soluble release material.
This is a lot code used by Stratasys to control the
manufacturing process.
This is the date that the spool was manufactured.
This is the date that the spool was first inserted in
a printer.
This is the amount of material that was on the
spool initially.
This is the amount of material currently on the
spool.
-427