Emptying The Purge Bucket; Replacing Material For Single Material Bay - HP Designjet 3D Service Manual

Emptying the purge bucket

Empty the purge bucket after each build to avoid part quality issues or
damage to the printer.
GLOVES: Wear gloves when emptying the purge bucket.
1. With a gloved hand, lift up on the purge bucket and pull it off of the two
mounts. See Figure 27.
Figure 27: Emptying the purge bucket
Purge bucket
2. Empty the purge bucket.
3. Place the purge bucket over the two mounts and push down to lock in
place.
CAUTION: When reinstalling the purge bucket, make sure that it
locks on both mounts and hangs flush with the chamber wall to
avoid damage.
Replacing material for single material
bay
1. From the display panel press Material... The display will show Add/
Remove and S1(remaining%) and M1(remaining%). Asterisks will
mark the currently active material bays (the material bays that are
currently loaded to the head).
2. Press Unload...
3. Select Unload both, Unload Model or Unload Support.
4. The printer will now unload material from the head. When the material
has unloaded, you will need to replace the material carriers.
5. Open the material bay doors by gently pressing in to release and pull-
ing outwards.
-47