Tip wipe assembly
If the XY Table or Z stage has been replaced or leveled, the tip wipe
assembly will need to be adjusted to ensure proper functionality.
Required Tools
Adjusting tip wipe assembly height:
1. Remove tip wipe assembly by pulling out of tip wipe bracket. See
2. Remove the plastic screw caps by prying apart with a standard screw-
3. Insert the tip wipe assembly height block into the tip wipe assembly
-402
•
Standard screwdriver
•
7/64" allen wrench
•
Tip wipe height block
417
driver. See
Figure 417
Figure 417: Tip wipe assembly location
bracket. See
Figure 418
Figure 418: Tip wipe assembly height block
Figure