Installing The Z Foam Level Assembly - HP Designjet 3D Service Manual

8. Remove the Z foam level assembly and discard.

Installing the Z Foam Level Assembly:

1. Remove the Z foam level bar from the assembly by pushing the actuator
2. Align the housing with the mounting holes and use a
3. Insert the actuator and spring into the housing and push all the way up.
4. Slide the bar to the left and into the housing, when installed correctly the
5. Reinstall the Substrate sensor. See
6. Reinstall the side panels. See
7. Reinstall the top panel. See
8. Reconnect the AC power cord, RJ-45 network cable and UPS cable (if
9. Power on the system. The system should reach Idle with no displayed
10. Run a small test part and monitor system operation during build.
-224
Figure 155: Z foam level assembly mounting screw locations
into the housing and pulling the bar to the right.
to reinstall the 4 mounting screws and washers.
actuator will not come out of the housing.
page 222
used).
errors.
4 mounting screws
"Installing the substrate sensor" on
"Side Panels" on page 162
"Installing the top panel" on page 162
3
⁄ " allen wrench
32