Part Quality Troubleshooting; Embedded Support Strands In Model - HP Designjet 3D Service Manual

Hide thumbs Also See for Designjet 3D:

Table of Contents

Part Quality Troubleshooting

Characteristics: Strands of support material embedded in model.

Example of embedded support

Corrective actions:

1. Change the part orientation. Rotate part 90 degrees - see example

2. Build the part using the "Minimal" support option.

3. Material is built-up on the shields. Using a brush to remove the excess

4. Replace tip shields.

5. Check brush flicker assembly for damage or wear. If worn or damaged,

replace brush flicker assembly.

6. Tip(s) are loose, check if tip screws are loose. Tighten tip screws.

7. Replace support material.

Problem corrected after re-orientation