HP Designjet 3D Service Manual page 306

Remove the left front Y
guide rod mounting
screw
29. Using a
30. Lift the front of the left Y guide rod upward until it is near the top of the
31. Rotate the left side Y guide rod towards the center of the printer and
32. Pull the left side Y guide rod out towards the door opening.
33. Angle the rest of the XY table out through the chamber door to remove
-290
Figure 259: Left side front Y guide rod mounting screw location
5
⁄ " allen wrench, remove the left side rear Y guide rod mount-
32
ing screw. See Figure 260.
Figure 260: Left side rear Y guide rod mounting screw location
Remove the left rear Y
guide rod mounting
screw
frame.
lower the guide rod.
from the printer.