HP Designjet 3D Service Manual page 67

Figure 30: Rewinding the material spool
7. Using a cutters, cut the excess 2 inches (50mm) of material from the
material guide, leaving a blunt end.
8. Locate the two material retaining clips on the carrier. See
Figure 31: Material retaining clips
Material retaining clips
9. Place the material guide in the material guide slot on the spool. See
ure 32.
10. Place the material in the material notches. See
Figure 32: Material guide slot and notches
Figure 31.
Fig-
Figure 32.
-51