HP Designjet 3D Service Manual page 290

12. Using a
13. Using a
14. Pull the right side Y belt out from the retaining clip.
15. Decrease the Y belt tension by turning the tensioning nut
-274
Figure 233: Left side Y belt retaining clip mounting screw locations
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws
5
⁄ " box wrench, remove the outer Y belt retaining clip mount-
16
ing screws from the right side. See
5
⁄ " box wrench, loosen, but do not remove, the inner Y belt
16
retaining clip mounting screws from the right side. See
Figure 234: Right side Y belt retaining clip mounting screw locations
Remove the outer
mounting screws
Loosen, but do not
remove the inner
mounting screws
Figure 234.
Figure 234.
(Figure 235.).