Installing The Display Panel; Front Panel; Removing The Front Panel - HP Designjet 3D Service Manual

5. Remove the display panel.

Installing the display panel

1. Connect the J1 Connector.
2. Gently push the display panel into place.
3. Close the display panel access hatch.
4. Close the chamber door.

Front Panel

Required Tools
Hardware

Removing the front panel

1. Open the chamber door.
2. Remove the display panel. See
3. Using a
-166
Figure 71: Disconnecting the J1 connector
5
• ⁄ " nut driver or standard screwdriver.
16
1
• 10-32 x ⁄ " slotted screws (x8)
2
page 165
5
⁄ " nut driver or standard screwdriver, remove the 2 mounting
16
screws from behind the display panel. See
"Removing the display panel" on
Figure 72.