HP Designjet 3D Service Manual page 385

Figure 372: Measuring distances from outside edges of E and I
31. Measure and record the diameter of circle E along the center line
between A and I. See
Figure 373: Measuring diameter of circle E
32. Add the lengths derived from steps 30 and 31 (A-E and E-I) and then
subtract the width of circle E derived from step 32. Record this total as
"GLF"
33. Enter the Service Calibration menu by pressing the following button
sequence on the display panel: 3,2,3,3,1. See
34. Press the Edit Configuration button.
35. Press the GLeft button. Enter the value recorded from step
ing the Increment, Decrement and Next Digit buttons.
NOTE: The value for GLeft must be between 5.250" and 5.750".
36. When finished, press Done...
Figure 392
Figure 354.
by press-
18
-369