Installing The X Motor - HP Designjet 3D Service Manual

1 1. Using a
Remove the 4
mounting screws
12. Remove the X motor from the X motor mounting bracket.

Installing the X motor

1. Place the X belt around the X motor pulley.
2. Align the X motor into the X motor mounting bracket making sure the X
3. Using a
4. Align the X motor mounting bracket with the mounting holes.
5. Using a
-256
Figure 206: X motor mounting bracket mounting screw locations
Remove the 4
mounting screws
9
⁄ " allen wrench, remove the 4 X motor mounting screws from
64
the mounting bracket. See
Figure 207: X motor mounting screw locations
motor cable faces the front of the printer.
9
⁄ " allen wrench, reinstall the 4 X motor mounting screws.
64
5
⁄ " nut driver or standard screwdriver, reinstall the 4 X motor
16
mounting bracket mounting screws.
Figure 207.