Powering Off; Resuming Operations From Standby Mode; Updating Printer Firmware; Installing The Firmware - HP Designjet 3D Service Manual

Powering off

To power off the printer, turn the power switch to the OFF position. You can
do this at anytime without harming the printer. No other steps are necessary.
If this is done while the printer is building a part, the current part will not be
completed.
NOTE: System cooling fans and lights will continue to operate for
several minutes after the switch has been turned off.
Resuming operations from Standby
mode
After several minutes of inactivity, the printer will enter Standby mode.
During Standby, the head temperature will decrease to conserve energy.
From the display panel press Resume.

Updating printer firmware:

Check http://www.hp.com
upgrade to the printer firmware, download the upgrade and install on the
printer.

Installing the firmware:

1. From the printer display panel, press Maintenance.
2. Press System.
3. Press Load Upgrade. The printer will then display "Send upgrade from
workstation" followed by the printer's IP address.
4. Open HP Designjet 3D Software Solution and click on the Printer Ser-
vices tab.
5. Click on the Update Software button. HP Designjet 3D Software Solution
will now connect to the printer and will prompt you to locate the
upgrade file. Navigate HP Designjet 3D Software Solution to the direc-
tory where the upgrade file is located. The update will automatically be
loaded on to the printer. After the update has been loaded, the display
will show Verifying update.
6. When verification is complete, the display will show Reboot to complete.
Press Yes. The printer will now reboot and return to Idle.
7. Press the Maintenance button and verify the updated version was
installed correctly then exit maintenance.
for printer firmware updates. If there is an
-53