Installing The Power Switch - HP Designjet 3D Service Manual

8. Press the Power Switch tabs in and push it out of the housing. See
Press tabs to
release

Installing the power switch

1. Push the power switch into place on the power switch housing.
2. Connect the yellow NC wire to the spade connector labeled "2a".
3. Connect the green COM wire to the spade connector labeled "2".
4. Connect the black SW3 wire to the spade connector labeled "1a".
5. Connect the white SW2 wire to the spade connector labeled "3".
6. Align the power switch housing with the mounting holes.
7. Using a
8. Reinstall the left side panel. See
9. Install the top panel. See
-200
Figure 1 17: Power switch connector locations
1 18.
Figure 1 18: Removing the power switch
5
⁄ " nut driver or standard screwdriver, reinstall the 2 mounting
16
screws.
page 164
"Installing the side panels" on
"Installing the top panel" on page 162
Figure
Press tabs to
release