HP Designjet 3D Service Manual page 234

12. Install tips into the heater blocks.
13. Install tip shields onto the tips.
14. Reinstall the air plenum.
15. Reinstall the head cover.
16. Reinstall the right side access cover.
17. Reinstall the side panels. See
18. Reinstall the top panel. See
19. Power the printer up.
20. Enter tip offset value (On tag attached to replacement toggle head):
-218
A. For printer firmware version 9.1 or newer:
i. While the printer is at Idle, enter standby mode by pressing the
Standby... button.
ii. Enter the Service Calibration menu by pressing the following
button sequence on the display panel: 3,2,3,3,1. See
Figure 148: Service Calibration button sequence
Button 0
Button 1
Button 2
Button 3
iii. Press the Edit Configuration button.
iv. Press the Next... button.
v. Press the Next... button.
vi. Press the ZT2T (Z tip to tip) button.
vii.Enter the calibration value from the tag that came with the
replacement toggle head assembly by pressing the Increment,
Decrement and Next Digit buttons.
NOTE: The value for ZT2T must be between -0.0500" and
0.0500".
"Installing the side panels" on page 164
"Installing the top panel" on page 162
Figure 148.