Auto Power Down; Cancelling Auto Power Down - HP Designjet 3D Service Manual

1 1. Cut the excess material from material guide.
12. Place the material retaining clips on the spool before removing the spool
from the carrier. See
A. Push the material retaining clips over the material and clip
on to the material spool.
B. Push the material retaining clips down until they lock in
place.
Figure 33: Installing material retaining clips
Place clip and push down to lock in place
13. Remove the material spool from the material carrier. See
Figure 34: Properly installed material retaining clips.
14. Place the material spool in the storage bag that came with the material
carrier.
NOTE: When not loaded in the printer, always store material spools
in the material carrier or the storage bag that came with the carrier
to prevent moisture absorption.

Auto power down

You can set the printer to automatically power down when a build is
complete. This option will save energy usage.
1. While the printer is building, press the Auto Power Down button.
2. Turn the power switch, located on the left side of the printer, to the OFF
position.
The printer will display Auto Power Down Mode and the printer will power
down as soon as the build is complete.

Cancelling auto power down:

1. Turn the power switch back to the ON position.
Figure 33.
Figure 34.
-52