System Firmware Overview - HP Designjet 3D Service Manual

System firmware overview

-38
• Idle: If there is no part being built and no part in the build queue,
the display will show that the printer is Idle.
• Wait for Part or Start Part: If the printer is in Idle and the build
queue is empty, you can set it to wait for a part. If the printer has a
part in the build queue, you can press Start Part to start a build.
• Building: If the printer is building a part, you can choose to pause,
set the lights either ON or OFF, view the print time or material
remaining and set the printer to auto power down.
• Material: From this section you can load material, unload material
or replace material.
• Standby: From this section you can set the printer to Standby mode.
• Maintenance: From this section you can make changes to the Sys-
tem, Setup or Machine.
Figure 24: Display panel hierarchy
Wait for Part/Start Part
Building
• Pause
• Lights Off
• Show Time
• Auto Power Down
• Set Network
• Test Parts
• Load Upgrade
Idle
Material Standby
• Load Material
• Unload Material
• Replace Material
System Setup
• Lights Always On
• Select Language
Maintenance
Machine
• Gantry
• Head
• Tips