Performing Part Based Calibration For Hp Designjet Color 3D From The Service Calibration Menu (Firmware Version 9.1 Or Newer) - HP Designjet 3D Service Manual

Performing part based calibration for HP Designjet Color 3D from the
Service Calibration menu (Firmware version 9.1 or newer)
1. While the printer is at Idle, enter standby mode by pressing the
2. Enter the Service Calibration menu by pressing the following button
3. Press the Reset Part Based Calibration button.
4. The printer will ask "Do you want to zero settings and reboot?" Press
5. Reboot the printer.
6. Once the system displays Idle, press Maintenance>System>Test Parts
7. When part is completed, remove from printer and let cool for five min-
8. Locate the filled circle, this indicates the front of the substrate, see
-360
Standby... button.
sequence on the display panel: 3,2,3,3,1. See
Figure 354: Service Calibration button sequence
Button 0
Button 1
Button 2
Button 3
Yes.
then select the test_XY_cal part.
utes.
355
Figure 354.
Figure