Installing The Controller Board - HP Designjet 3D Service Manual

Figure 91: P104 connector location
P104 Connector

Installing the controller board

1. Align the pins of the controller board with the P104 connector of the
SBC and gently press down in to position.
2. Using a Phillips screwdriver, reinstall the 6 mounting screws.
3. Reconnect the diagnostics DB-9 connector to the controller board.
4. Using a standard screwdriver, tighten the 2 mounting screws.
5. Reconnect the 3 ribbon cables to the PDB.
6. Close the Electronics Bay. See
page 172
7. From the workstation, open the HP Designjet 3D Software Solution.
8. Connect to the printer.
9. Insert the printer firmware CD into the workstation CD drive.
10. From the Printer Services tab, click on the Update Software button.
1 1. Navigate HP Designjet 3D Software Solution to the Upgrade (.UPG) file
on the printer firmware CD.
12. The printer will load, reboot and verify the upgrade.
"Closing the electronics bay" on
-181