Hard Drive Installation Checklist - HP Designjet 3D Service Manual

Hard Drive Installation Checklist

-420
Replace the hard drive.
Verify that all cables are connected correctly.
Clean and vacuum the system.
Power system up.
After 10 minutes to 45 minutes, the LCD will display UPGRADE and
Send Upgrade From Work Station along with the Dynamic IP Address
of the system (the default system setting).
NOTE: For convenience, the assigned IP address is visible in the
display panel during this process.
• If the system will be operating in a Dynamic environment, the UPGRADE
can be loaded from the PC.
Use the Manage 3D Printers button in HP Designjet Software Solution to
connect to the printer -Choose "Add from Network..."
• If the system will be operating in a Static environment, choose
work...
from the display panel and enter the appropriate network
addresses. The customer should provide this information.
After all the addresses have been edited, select Done.
Use the Manage 3D Printers button in HP Designjet Software Solution to
connect to the printer - Choose "Add Manually..."
NOTE: The printer firmware must be downloaded before system
operation can continue.
Download the printer firmware using the most current version. Download
instructions for performing the download procedure are located on the
firmware CD.
Once download is complete, system will reach "Idle".
Load material.
Run a small test part to ensure part quality is acceptable and that the
system is operating properly.
Set Net-