Reset Button; Dip Switches - HP Designjet 3D Service Manual

Figure 4: Controller board connection detail

Reset Button

Located on the lower right side of the board, the reset button will do a hard
reset of the controller board. Before continuing with normal operation after
resetting the board, system power must be cycled before building. The reset
button should only be used after using Tera Term.

Dip Switches

There are three dip switch banks (SW2, SW5, SW6) located on the top right
side of the board. Dip switches are factory set and should not be changed
unless noted to be in another position.
-11