Material Tubes; Removing The Material Tubes; Installing The Material Tubes - HP Designjet 3D Service Manual

Material Tubes

Required Tools

Removing the material tubes

1. Remove the top panel. See
2. Remove the side panels. See
3. Remove the upper electronics bay cover. See
4. Remove the umbilical hose. See
5. Feed the material tubes out through the energy chain.

Installing the material tubes

1. Feed the material tubes through the energy chain.
2. Reinstall the umbilical hose. See
3. Reinstall the upper electronics bay cover. See
4. Reinstall the side panels. See
5. Reinstall the top panel. See
-246
5
• ⁄ " nut driver or standard screwdriver
16
1
• ⁄ " nut driver
4
5
• ⁄ " allen wrench
32
• Cutters
tronics bay cover" on page 173
page 241
page 245
tronics bay cover" on page 174
"Removing the top panel" on page 161
"Removing the side panels" on page 162
"Removing the upper elec-
"Removing the umbilical hose" on
"Installing the umbilical hose" on
"Installing the upper elec-
"Installing the side panels" on page 164
"Installing the top panel" on page 162