Installing The Door Solenoid; Door Sensor; Removing The Door Sensor - HP Designjet 3D Service Manual

Figure 75: Removing the door solenoid

Installing the door solenoid

1. Push the solenoid pin out and slide door solenoid into place on the
mounting plate.
2. Reconnect the DRSOL cable.
3. Reinstall the front panel. See
4. Reinstall the display panel. See
page 166

Door Sensor

Required Tools
5
• ⁄ " nut driver or standard screwdriver.
16

Removing the door sensor

1. Remove the display panel. See
page 165
2. Remove the front panel. See
3. Disconnect the DRSW cable. See
Figure 76: Door sensor cable location
Disconnect the DRSW cable.
4. Gently pull the door sensor out of the mounting plate. See
Figure 77: Removing the Door Sensor
"Installing the front panel" on page 168
"Installing the display panel" on
"Removing the display panel" on
"Removing the front panel" on page 166
Figure 76.
Figure 77.
-169