Installing The Umbilical Cable - HP Designjet 3D Service Manual

7. Disconnect the umbilical cable from the TC Amp board by pressing in
8. Feed the umbilical cable out through the energy chain.

Installing the umbilical cable

1. Feed the umbilical cable through the energy chain.
2. Reconnect the umbilical cable to the TC Amp board.
3. Reconnect the umbilical cable to the head board.
4. Reconnect the umbilical cable to the I/O card.
5. Reinstall the umbilical hose. See
6. Reinstall the upper electronics bay cover. See
7. Reinstall the side panels. See
8. Reinstall the top panel. See
-248
Figure 194: Head board connector location
Disconnect the
umbilical cable
on the tab and pulling outward. See
Figure 195: TC Amp connector location
Disconnect the
umbilical cable
page 245
tronics bay cover" on page 174
Figure 195.
"Installing the umbilical hose" on
"Installing the upper elec-
"Installing the side panels" on page 164
"Installing the top panel" on page 162