Installing The Electronics Bay - HP Designjet 3D Service Manual

8. Slide the electronics bay out 3 inches (76mm) and disconnect the cables
9. To remove, slide the entire electronics bay out from the back of the

Installing the electronics bay

1. Slide the electronics bay into position, leaving 3 inches (76mm).
2. Connect the 4 rear power distribution board cables.
3. Slide the electronics bay back into position
4. Using a
5. Connect the I/O card cables.
6. Reinstall the upper electronics bay cover. See
7. Reinstall the side panels. See
8. Reinstall the top panel. See
-176
Figure 84: Electronics Bay mounting screw locations
Remove the 4 right side
mounting screws
from the rear of the power distribution board. See
Figure 85: Power distribution board rear cable locations
PDB rear cable locations
printer.
5
⁄ " nut driver or standard screwdriver, reinstall the 4 left and 4
16
right side mounting screws.
tronics bay cover" on page 174
Remove the 4 left side
mounting screws
Figure 85.
"Installing the upper elec-
"Installing the side panels" on page 164
"Installing the top panel" on page 162