HP Designjet 3D Service Manual page 218

7. Disconnect the J1 connector on the 24VDC power supply. See
8. Disconnect J3 1 through 4 connectors using a Phillips screwdriver. Note
Disconnect J3 1
through 4
9. Close the rear panel of the electronics bay and remove the 2 board
-202
120.
Figure 120: J1 cable location
the position of the wires for reinstallation. See
Figure 121: J3 1 through 4 connector locations
mounting screws using a Phillips screwdriver. See
Figure
Disconnect J1
Figure 121.
Figure 122.