5. Squeeze the tabs on the circuit breaker and push through the electronics
bay panel. See
Figure 1 13.
Figure 1 13: Removing the circuit breaker
Installing the circuit breaker
1. Push the circuit breaker through the electronics bay panel until it locks in
place.
2. Reconnect the CB1 and CB2 spade connectors to the circuit breaker.
3. Reconnect the Load and CB1 spade connectors to the circuit breaker.
4. Close the electronics bay. See
page 172
AC Input
Required Tools
5
•
⁄
" nut driver or standard screwdriver.
16
•
Phillips screwdriver
Hardware
1
•
⁄
" x 6mm Phillips pan head screws (x2)
2
Press tabs and push the
circuit breaker through
the panel
"Closing the electronics bay" on
-197