19. Connect the long red striped material tube (M2) from model (M) coupler
20. Repeat with long black striped (S2) material tube for support side. See
21. Connect a material bay cable between the printer and the top connector
22. Connect the other material bay cable between the bottom connector of
-34
Figure 20: Connecting the short material tubes
of lower material bay to right side of model Y block by inserting firmly
into red couplers. Gently pull the tube to ensure it is properly inserted.
Figure 21.
Figure 21: Connecting the long material tubes
on the upper material bay.
the upper material bay to the top connector of the lower material bay.
See
Figure 22.