The Display Panel During Build; Chamber Lights - HP Designjet 3D Service Manual

The display panel during build

The top two lines of the display panel will show the printer status. See
26.
support material that remains in the carriers.

Chamber Lights

When a part starts to build, the chamber lights are automatically ON. The
default time-out for the lights is 30 minutes. You can toggle the lights ON or
OFF through the display panel.
You can set the chamber lights on permanently, however the chamber lights
will return to factory settings when power is cycled.
1. From Idle or Ready to Build, on the display panel press Maintenance.
2. Press Setup.
3. Press Lights Always On.
Repeat this process to turn this option off.
-44
The bottom line of the display panel will show the amount of model and
Figure 26: Display panel during build
Printer status
Model file name
Support material
remaining
Printer status
Model file name
Support material
remaining in bay 1
Support material
remaining in bay 2
NOTE: If a material amount is flashing, it indicates that the
remaining material will not be enough to complete the current build.
Single material bay
Dual material bay
Figure
Model material
remaining
Model material remaining
in bay1
Model material remaining
in bay2