Controller Board Checklist - HP Designjet 3D Service Manual

Controller Board Checklist

Use this checklist when replacing the controller board. Due to possible
software version conflicts, additional steps must be taken after installing a
controller board - the complete (X, Y, Z) homing process must be run before
building a part.
Unload material.
Power down the system.
Replace the controller board.
Power up the system
When prompted, download the printer firmware.
Enter Head Maintenance. This will cause the system to run the complete
homing process.
Exit Head Maintenance
Load material.
Run a small test part to ensure part quality is acceptable and that the XY
table is functioning correctly.
-423