HP Designjet 3D Service Manual page 269

Figure 200: Left side access panel mounting screw locations
Remove the 7
mounting screws.
5
4. Using a ⁄ " nut driver or standard screwdriver, remove the 7 right side
16
access panel mounting screws and remove the right side access panel.
See Figure 201.
Figure 201: Right side access panel mounting screw locations
Remove the 7
mounting screws.
1
5. Using a ⁄ " box wrench, remove the X belt tension adjuster by loosen-
2
ing the inside nut and then backing the bolt out of the mount. See
202.
6. Remove the tensioning fork and pulley from the X motor belt.
Figure
-253