Epson C Series Maintenance Manual page 240

C8 Maintenance 3. Covers
C8-A1401** (C8XL)
Removal 1. Remove the fan.
2. Remove the bolts on the heat sink
3. Remove the heat sink.
NOTE

4. Remove the bolts, and then remove the connecter plate. and
NOTE

C8-A1401** (C8XL)
Installation 1. Install the spacers to the holes on the gasket.
2. Apply the liquid gasket to the base rear gasket.
NOTE

220
For details, refer to C8 Maintenance 15. Replacing the Fan.
Hexagon socket head cap bolts: 4-M4×15
For cleanroom and protection models, remove the gasket
between the heat sink and the connecter plate.
the base rear gasket.
Hexagon socket head cap bolts: 11-M4×10
The gasket has the spacers. Be careful not to lose them.
(11 places)
Install the base rear gasket to the base cover.
(See the figure for gasket applying points)
Gasket
Applying
point (×11)
After applying the liquid gasket, leave the gasket until the liquid gasket becomes
solid and the gasket is fixed.
Spacer (×11)
Base rear gasket
Base cover
C Series Maintenance Manual Rev.2