Epson C Series Maintenance Manual page 50

6-axis robots

Hide thumbs Also See for C Series:

Table of Contents

C4 Maintenance 4. Cable Unit

5. Secure the Arm #2 cable fixing plate and the cable unit.

Plate and spring

Cable unit and plate : Wire tie AB150, Mark tube 65 mm

Precautions for cable unit fixation to the plate:

Pass the mark tube and the wire tie through the hole of the plate

as shown in the photo on the right.

When installing the cable unit, place the plate, the air tube, and

the cables as shown in the photo on the right (example), and then

fix the plate and the cable unit with a wire tie.

6. Insert the cable unit with the cable protection spring (ø 17.5) from the

7. Wrap the end of the spring to the Arm #4 cable fixing plate with a

Wire tie: AB100 × 1

Number of turns of spring to fix: 3 turns

: Wire tie AB100

C Series Maintenance Manual Rev.2