Joint #1 Reduction Gear Unit (Ceiling Mounting, Wall Mounting); Joint #1 Reduction Gear Unit - Epson C Series Maintenance Manual

6-axis robots

Hide thumbs Also See for C Series:

Table of Contents

1. Remove the base grease inlet cover.

2. Remove the O-ring located in the base groove.

3. Remove the grease plug from the Joint #1

4. Attach the grease line extension jig and grease

5. Inject grease from the grease nipple using a

6. Remove the grease nipple and grease line

7. Attach the grease plug to the Joint #1 grease

8. Apply a thin coat of grease (SK-1A) to the O-ring.

C Series Maintenance Manual Rev.2

(Ceiling Mounting, Wall mounting)

Hexagon socket flat head bolts: 4-M3×6

grease inlet located inside the base.

nipple to the Joint #1 grease inlet.

Grease: SK-1A

Grease amount: 11g

extension jig from the Joint #1 grease inlet.

If the grease plug is damaged or deteriorated,

replace it with a new one.

Fit the O-ring into the base groove.

Do not allow the O-ring to come out of the groove.

If the O-ring is swollen, damaged, or deteriorated, replace it with a new one.

C8 Maintenance 2. General Maintenance