Toshiba GR200 Series Instruction Manual page 19

configuration module (and the
(See Chapter
VCT#1, VCT#2
Filter
CT×n
I
VT×m
V
HMI
LCD/Large LCD
LEDs
Operation keys
Monitoring jacks
Function Key
USB
Local PC
I/F
PSW
Power
Note: The structure for the Dual ports plus LAN for Local PC is shown in the dash
dotted line. The OPT2 is not included in the stand-alone type of the MainUnit.
SubUnit hardware
(ii)
Figure 1.1-5 shows modules implemented in the SubUnit(1/1 case). PWS, BIOs, VCTs, and
CPU are provided. The OPT2 is mounted on CPU, which is used to connect with the MainUnit.
Figure 1.1-6 shows a block diagram of the SubUnit. Note that the HMI is not mounted on the
front of the SubUnit.
number of modules), see
Installation and setting: Unpack and inspection of hardware and software
Designed for the Max Dual ports
CPU
LAN I/F
A/D
CP1M
LAN I/F
P OPT2
BO1A
BI1A
BIO5A
Designed for the Stand-alone type
(The MainUnit is not connected with SubUnits.
CPU
CP1M
LAN I/F
LAN I/F
LAN I/F
IRIG-B
RS-485
Figure 1.1-4 MainUnit hardware block diagram
the
Communication
Network for SAS,
etc.
SubUnit#1
SubUnit#2
Auxiliary
Binary output
relay
×18
Photo coupler
Binary input
×18
Auxiliary
Binary outputs
relay
×9
Photo coupler
Binary inputs
×9
Communication
Network for SAS,
etc.
LAN for
engineering
tools
- 5 -
6F2S1931 (0.20)
IO configuration label on the case
Designed for the Dual ports with LAN for Local PC
CPU
CP1M LAN I/F
LAN I/F
LAN I/F
PCX
P OPT2
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
).
Communication
Network for SAS,
etc.
LAN for
engineering
tools
SubUnit#1
SubUnit#2