Toshiba GR200 Series Instruction Manual page 717

Mode change screen
(iv)
When the user selects "Mode Change" from the Test sub-menu shown in Figure 11.8-1, the
following Mode change screen is displayed (Figure 11.8-13). This allows control from a remote
device (For example, SAS server) by configuring the MDCTRL-EN setting.
Figure 11.8-13 Mode Change sub-menu
Signal monitoring screen
(v)
Figure 11.8-14 shows that the user can assign signal-monitoring points to the monitoring jacks
(A, B, and C) on the IED front panel. Incidentally, points have not been assigned for the
monitoring jacks in the menu below.
Figure 11.8-14 Signal monitoring sub-menu
When the user wishes to use monitoring jack A to monitor a signal-monitoring point,
select "Term A" in the signal monitoring sub-menu (Figure 11.8-15). The user can then assign
the signal monitoring point for Term A.
Mode Change
10:48
MDCTRL-EN
Off
MDCTRL-SELRST
30
MDCTRL-EXERST
30
Signal Monitoring
10:48
Term A
No Assign
Term B
No Assign
Term C
No Assign
10:48
Input signal
No Assign
Figure 11.8-15 Selection menu
- 703 -
1/3
+
+
s
+
s
1/3
+
+
+
1/3
+
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)