Toshiba GR200 Series Instruction Manual page 302

How to set the settings for binary output circuits
(vii)
Figure 4.4-5 BIO modules and setting tables related to IO_SLOT2 and IO_SLOT3
Figure 4.4-5 illustrates an example of a binary IO module arrangement and the binary
output circuit printed circuit boards (PCBs). If the user wishes to set the binary output circuits,
the setting targets are at locations IO#2 and IO#3. The user should key the CPL settings from
the setting tables for the IO2_SLOT and IO3_SLOT.
The setting table is available for all binary IO modules; thus, the user should understand
and select setting points that are relevant to BIO5A. That is, the user should choose the setting
terms of reference (i.e., binary output circuits #1 to #9) from IO_SLOT2. These setting tables
BIO5A
IO_SLOT2
Setting table (output)
Setting targets: BO1–BO9
b. Setting targets for BIO5A (IO#2)
- 288 -
BIO5A
IO_SLOT3
Setting table (in & out)
Setting targets: BO1–BO9
c. Setting targets for BIO5A (IO#3)
Centralized GRB200
(Soft: 030, 031, 032, 033, 034)
6F2S1931 (0.20)